Nowadays, few manufacturers conduct professional training on the operation of winding machine, stranding machine, and high torque winding machine, nor do they carry out taboo guidance. Gusu Shuangqing has been engaged in the research and development of winding machine, stranding machine, and high torque winding machine for more than 10 years, and often receives phone calls from customers, reflecting that the winding machine is not useful. In fact, most of the reasons are caused by the operator's mistakes or carelessness, which also brings economic loss to the manufacturer. The following will introduce the operation matters of the winding machine usually used to help the company reduce the loss.

The winding machine is a special equipment for winding coils. To operate, swing the handle by hand, the big gear rolls and then the pinion rolls (the speed ratio is l: 4 or 1:8), and the pinion rolls the main shaft. The winding die is secured with two end fastening nuts. In addition, there is a vertical screw strand actuating coil counter gear, so that the indicator of the coil counter corresponds to the speed of the gear, and then records the number of turns of the coil. When winding, the wire is drawn from the pay-off frame, and one end of the wire is fixed at one end of the winding die, and the wire can be started.

If the winding machine you purchase is not a fully automatic winding machine, then the taboos in operation are as follows:

(1) Pay attention to the tension of the wire to be appropriate, to prevent too much or too small.

(2) The energy should be concentrated when winding, and the number of turns of the coil should be accurate. Stop winding turns fault.

(3) The turns should be placed neatly to prevent scattered placement.

(4) Stop loose and tight when winding, and force should be uniform.